DigiCoat Translucent White   Decorating glass products like tiles or cutting boards with sublimation inks can produce stunning images. Sublimated images must however be applied to the back of the glass. The results of the final image can be disappointing and appear washed out and faded unless the transfer is top coated with a finish.   DigiCoat Translucent White provides a solution. It is specially developed to enable the sublimation image to transfer straight through and to fix itself in the clear coating below and resulting in a vibrant image. No more washed out images on glass ! This coating is applied as an overcoat to DigiCoat Clear and cures at 160 degrees for 15-20 minutes.   How to use : Shake can well for 1 minute Ensure the surface to be coated is clean dry and free from grease Prime surface with adhesion promoter Coat glass first with DigiCoat Clear (allow to air dry for 5 mins) then apply Translucent White over clear coating. Only a fine coat is required. For best results apply at room temperature from a distance of around 250 mm (10") Cure in oven to 160°C (320°F) for 15-20 mins